Honda CB 600F Hornet 2007 Shop Manual page 364

FRONT WHEEL/SUSPENSION/STEERING
Remove the right handlebar switch/thronle housing
screws.
Disconnect the thronle cable ends from the throttle
pipe and remove the right handlebar switch/throttle
housing.
Remove the right handlebar grip/throttle pipe.
Remove the bolts and handlebar upper holders.
Remove the handlebar.
INSTALLATION
Place the handlebar on the lower holders aligning
the punch mark on the handlebar with the edge of
the lower holder.
Install the handlebar upper holders with its punch
marks facing forward.
Install the holder bolts.
nghten the front bolts first, then tighten the rear
bolts to the specified torque.
TORQUE: 27 N-m (2.8 kgf-m, 20 lbf.ft)
13-10
SWITCHfrHROTTLE HOUSING
RKS BOLT