-
6. Failure Reproduction with a New Speed Sensor
Replace the front wheel speed sensor with a new
one (page 16-24).
Connect the ABS modulator 25P connector.
Erase the problem code (page 16-9).
Perform the pre-start self-diagnosis and check
the ABS indicator (page 16-7).
YES
-
Faulty ABS modulator.
Dose the indicator blink?
NO
- Faulty removed wheel speed sensor.
PROBLEM CODE 13, 14, 23 or 43 (Rear
Wheel Speed Sensor)
• The ABS indicator might blink under unusual
NOTE:
riding or conditions (page 16-10). This is tempo
rary failure. Erase the problem code and perform
the pre-start self-diagnosis before troubleshoot
ing. The ABS is normal if the indicator goes off.
• If the problem code 43 is indicated, check the
rear brake for drag.
Measure the air gap between the speed sensor
1. Speed Sensor Air Gap Inspection
and pulser ring (page 16-24).
YES
-
GO TO STEP 2.
Is the sir gap correct?
NO
- Check each part for deformation and
looseness
and
Recheck the air gap.
2. Speed Sensor Condition Inspection
Inspect the area around the speed sensor:
Check that there is iron or other magnetic depos
its between the pulser ring and wheel speed sen
sor, and the pulser ring slots for obstructions.
Check installation condition of the pulser ring or
wheel speed sensor for looseness.
Check the pulser ring and sensor tip for defor
mation or damage {e.g., chipped pulser ring
teeth).
Are the sensor and pulser ring in good condi
YES
- GO TO STEP 3.
tion?
NO
- Remove any deposits. Install properly
or replace faulty part.
ANTI-LOCK BRAKE SYSTEM (ABS; CB600FA)
,--------------------.
correct
accordingly.
ABS INDICATOR
//
1J
J
..
ttJ
«:/
� '!}
'@
@
_
1 '
l)
3
@
@
1
� ... ,;;v
�
w
-
16-13