Honda CB 600F Hornet 2007 Shop Manual page 406

REAR WHEEL/SUSPENSION
Drive the driven flange bearing/collar into the driven
flange using the special tools.
TOOLS:
Driver
Attachment, 52 X 55 mm
Pilot,20 mm
Install the driven sprocket and tighten the nuts tem­
porarily.
Install the wheel damper rubbers into the wheel
Replace the
hub.
damper rubbers as
8S91.
Apply engine oil to a new O-ring and install it into
the groove of the wheel hub.
Apply grease to the driven flange and rear wheel
hub contact area.
Install the driven flange assembly into the left wheel
hub.
14-12
07749-0010000
07746-0010400
07746-0040500
DRIVEN SPROCKET
\
- I
\
�
NUTS
DRIVEN FLANGE