CLUTCH/STARTER CLUTCH/GEARSHIFT LINKAGE
Remove the dowel pins.
Clean any sealant off from the right crankcase cover
mating surfaces.
NOTE:
Do not turn the crankshaft counterclockwise after
removing the right crankcase cover 10 prevent the
starter reduction gear from damage.
CLUTCH LIFTER LEVER
Remove the clutch lifter lever, return spring and
washer from the right crankcase cover.
Check the lifter lever spindle for wear or damage.
Check the return spring for fatigue or damage.
Check the lifter lever oil seal and needle bearings for
wear or damage.
Install the clutch lifter lever with the washer and
spring in the reverse order of removal.
CLUTCH
REMOVAL
Remove the right crankcase cover (page 9-5).
Remove the starter idle gear and shaft.
9-6
OIL SEAL