Honda CB 600F Hornet 2007 Shop Manual page 372

=RONT WHEEL/SUSPENSION/STEERING
Install the bearing remover head into the bearing.
From the opposite side, install the bearing remover
shaft and drive the bearing out or the wheel hub.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover head, 20 mm 07746-0050600
Bearing remover shaft
ASSEMBLY
Be flush with the wheel hub
Fully seated
.s
�
20 N·m (2.0 kgf·m, 15 lbf·ft)
PULSER RING �
(CB600FA)
�
;-
""
g �
��
7.0 N-m (0.7 kgf•m, 5.2 lbf·ft)
Drive in a new right bearing squarely with the
Jever install the old
marked side facing up until it is fully seated using
bearings Once the
the special tool.
bo;Jrmgs has been
removed, the
TOOLS:
bearing musr be
Driver
w,rh
replaced new
Attachment, 42 X 47 mm
ones.
Pilot,20 mm
Install the distance collar.
Using the same tools, drive in the left bearing
squarely with the marked side facing up until it is
fully seated on the distance collar.
13-18
07GGO-0010100 or
07746-0050100
7---.,
RIGHT OUST SEAL
��
... jjlll
RIGHT WHEEL BEARING (20 X 45 X 12)
RIGHT BRAKE DISC
07749-0010000
07746-0010300
07746-0040500
.s
�
LEFT WHEEL BEARING (20 X 45 X 12)