Honda CB 600F Hornet 2007 Shop Manual page 435

HYDRAULIC BRAKE
Loosen the pad pin.
Pull the pad pin out of the caliper body while hold­
ing the brake pads.
Remove the brake pads.
Make sure that the pad spring is in place.
Install new brake pads into the caliper so their ends
Always replace the
rest into the pad retainer on the bracket properly.
brake pads ,n pairs
to ensure even disc
pressure.
Coat the stopper ring on the pad pin end with the
silicone grease.
Install the pad pin by pushing in the pads against
the pad spring to align the pad pin holes in the pads
and caliper body.
Tighten the pad pin to the specified torque.
TORQUE: 17 N,m (1.7 kgf-m, 13 lbf,ft)
Operate the brake lever to seat the caliper pistons
against the pads.
FRONT BRAKE PAD REPLACEMENT
(CB600F)
Push the caliper pistons all the way in to allow
Check the brske
installation of new brake pads by pushing the cali­
f/u,d level m the
per body inward.
reservo,r as this
operation causes
the level to nse.
15-16