ANTI-LOCK BRAKE SYSTEM (ABS; CB600FA)
Release the sensor wire clips from the caliper
bracket.
Remove the wheel speed sensor mounting bolts
and guide.
Remove the wheel speed sensor from the caliper
bracket.
Clean around the mounting area of the caliper
bracket thoroughly, and be sure that no foreign
material is allowed to enter the mounting hole.
Install a new speed sensor in the reverse order of
Route the sensor
wire properly (page
removal.
1•23 J.
After installation, check the air gap (page 16-24).
ABS MODULATOR
REMOVAL
Drain the brake fluid from the front and rear hydrau
lic systems (page 15-7).
Remove the rear fender (page 2-8).
Pull the lock lever up and disconnect the ABS modu
lator 25P connector.
When loosening
Loosen the brake pipe joint nuts and disconnect the
the joint nuts, cover
brake pipes.
the end of the
brake pipes to
prevenr
contamination
16-26