Honda CB 600F Hornet 2007 Shop Manual page 292

Clutch plate
Replace rhe clurch Check the plates for discoloration.
Check the plate warpage on a surface plate using a
discs Bnd pl8tes as
feeler gauge.
a set.
SERVICE LIMIT: 0.30 mm (0.012 in)
Judder spring/spring seat
Check the judder spring and spring seat for defor­
mation, warpage or damage; replace as necessary.
• A damaged or warped spring seal will cause the
judder spring to be pressed unevenly.
• A damaged judder spring also causes the weak
contact between the discs and plates or uneven
disc/plate contact.
Clutch outer/primary driven gt,ar
Check the slots of the clutch outer for damage or
wear caused by the clutch discs.
Check the primary driven gear for abnormal wear or
damage.
Measure the 1.0. of the primary driven gear.
SERVICE LIMIT: 41.026 mm (1.6152 in)
Replace the clutch outer assembly if necessary.
Clutch outer guide/needle bearing
Measure the 0.0. and 1.0. of the clutch outer guide.
SERVICE LIMITS:
0.0.: 34.986 mm (1.3774 in)
1.0.:
Check the needle bearing turns smoothly and qui­
etly.
Replace the bearing if necessary.
CLUTCH/STARTER CLUTCH/GEARSHIFT LINKAGE
25.013 mm (0.9848 in)
JUDDER SPRING
CLUTCH OUTER
PRIMARY DRIVEN GEAR
-
-
SPRING SEAT
9-11