Honda CB 600F Hornet 2007 Shop Manual page 64

FRAME/BODY PANELS/EXHAUST SYSTEM
Install new gaskets to the exhaust ports.
Always replace rhe
gaskets with new
ones
Route the 0
&
Refer co 'CABLE
exhaust pipe.
HARNESS
ROUTING" (page 1-
Temporarily install the exhaust pipe joint nuts,
23 ).
exhaust pipe mounting bolts, collars, washers and
nuts.
Tighten the exhaust pipe joint nuts to the specified
torque.
TORQUE: 12 N•m (1_2 kgf•m, 9 lbf·ft)
Tighten the exhaust pipe mounting nuts to the spec­
ified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf•ft)
Secure the 02 sensor wire with clamp.
Connect the 02 sensor 4P (Black) connector.
Install the right side cover (page 2-4).
2-16
sensor wire properly and install the
2
GASKETS
r---,--:---=--.:::--,-r-:-::::-:-:-:::::-7:".
BOLTS/WASHERS/COLLARS/NUTS