Honda CB 600F Hornet 2007 Shop Manual page 570

SIGNAL LINE INSPECTION
Measure the voltage between the Pink wire terminal
(+) and ground (-).
There should be approx. S V when the ignition
switch is turned to "ON".
Disconnect the ECM 33P (Light gray) connector
(page 21-13).
Check the Yellow/blue wire for continuity between
the immobilizer receiver and ECM connectors.
TOOL:
Test probe
There should be continuity.
Check for continuity between the Yellow/blue wire
terminal and ground.
There should be no continuity.
REPLACEMENT
Remove the headlight unit (page 20-6).
Disconnect the immobilizer receiver 4P (Natural)
connector.
Remove the screws and the immobilizer receiver.
Install a new receiver and tighten the screws
securely.
Install the removed parts in the reverse order of
Route the rece,ver
w,re removal.
properly /page
1-23)
07ZAJ-RDJA 110
Yellow/blue
IMMOBILIZER SYSTEM (HISS)
4P (Natural) CONNECTOR
(Wire side/female terminals)
/-
Pink
4P (Natural) CONNECTOR
(Wire side/female terminals)
33P (Light gray) CONNECTOR B
(Wire side/female terminals)
21-15