Honda CB 600F Hornet 2007 Shop Manual page 463

HYDRAULIC BRAKE
Apply silicone grease to the inside of bracket pin
boot.
Install the boot and collar into the caliper body.
Install the pad spring onto the caliper body properly
as shown.
Check that the pad retainer is in place on the caliper .--- .... -----u­
bracket.
Apply silicone grease to the Inside of slide pin boot
and install the boot into the bracket.
INSTALLATION
nor ro Install the caliper main slide pin into the boot on the
Be careful
caliper l.,ra1;ket.
come the pad
spring off from the
caliper.
Connect the brake hose to the caliper with the oil
Hold the brake
,n bolt and new sealing washers.
hose the stopper
Then tighten the oil bolts to the specified torque.
groove on the
cahper.
TORQUE: 34 N•m (3.5 kgf•m, 25 lbf•ft)
Install the brake pads (page 15-17).
Fill and bleed the brake hydraulic system (page 15-
7) .
15-44
COLLAR
CALIPER BODY
PAD SPRING
�
BOOT