Honda CB 600F Hornet 2007 Shop Manual page 555

LIGHTS/METER/SWITCHES
2. Turn Signal Circuit Inspection
Remove the rear cowl (page 2-6).
Disconnect the turn signal 4P connector and
short the Gray and White/green terminals of the
wire harness side connector with a jumper wire.
Turn the ignition switch ON and check the turn
signal light by turning the turn signal switch on.
Does the light come on?
YES
NO
3. Ground Line Inspection
Check the continuity between the 4P connector
Green terminal and ground.
Is there continuity?
YES
NO
HEADLIGHT RELA V
Remove the rear cowl (page 2-6).
Remove the headlight relay from the rubber holder.
Disconnect the headlight relay 4P connector.
Connect the ohmmeter to the headlight relay con­
nector terminals.
CONNECTION: A (Black/red)
Connect the 12 V battery to the following headlight
relay connector terminals.
CONNECTION: C (Blue)- D (Green)
There should be continuity when the 12 V battery is
connected.
If there is no continuity when the 12 V battery is
connected, replace the headlight relay.
20-26
- GO TO STEP 3.
- Open circuit in related wires
- • Faulty turn signal relay
• Loose or poor contact
tor terminals
- Open circuit in Green wire
- B (Blue/black)
of the connec­
HEADLIGHT RELAY
r-1
A
V"'
I
BATTERY
t:1
C
@
D