Pgm-Fi Troubleshooting Information - Honda CB 600F Hornet 2007 Shop Manual

PGM-FI TROUBLESHOOTING INFORMATION

GENERAL TROUBLESHOOTING
Intermittent Failure
The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the MIL does not come on,
check for poor contact or loose pins at all connectors related to the circuit that of the troubleshooting. If the MIL was on,
but then went out. the original problem may be intermittent.
Opens and Shorts
"Opens" and "Shorts" are common electrical terms. An open is a break in a wire or at a connection. A short is an accidental
connection of a wire to ground or to another wire. In simple electronics, this usually means something will not work at all.
With ECMs this can something mean something work, but not the way it's supposed to.
If the MIL has come on
Refer to OTC READOUT (page 5-13).
If the MIL did not stay on
If the MIL did not stay on, but there is a driveability problem, do the SYMPTOM TROUBLESHOOTING (page 5-5).
SYSTEM DESCRIPTION
SELF-DIAGNOSIS SYSTEM
The PGM-FI system is equipped with the self-diagnostic system. When any abnormality occurs in the system, the ECM
turns on the MIL and stores a OTC in its erasable memory.
FAIL-SAFE FUNCTION
The PGM-FI system Is provided with a fail-safe function to secure a minimum running capability even when there is trouble
in the system. When any abnormality is detected by the self-diagnosis function. running capability is maintained by pre­
programed value in the simulated program map. When any abnormality is detected in the injector(s) and/or CKP sensor.
the fail-safe function stops the engine to protect it from damage.
OTC (Diagnostic Trouble Code)
• The OTC is composed of a main code and a sub code and it is displayed as a hyphenated number when retrieved from
the ECM with the HOS pocket tester.
The digits in front of the hyphen are the main code, they indicate the component of function failure.
The digits behind the hyphen are the sub code, they detail the specific symptom of the component or function failure.
For example. in the case of the TP sensor:
- OTC 08 - 1 = (TP sensor voltage)
- OTC 08 - 2 = (TP sensor voltage)
• The MAP. ECT, TP and IAT sensor diagnosis will be made according to the voltage output of the affected sensor.
If a failure occurs. the ECM determines the Function Failure, compares the sensor voltage output to the standard value,
and then outputs the corresponding OTC to the HOS Pocket Tester.
For example:
- If the input voltage line (A) on the MAP sensor is opened, the ECM detects the output voltage is about 5 V, then the
OTC 1-2 IMAP sensor circuit high voltage) will be displayed.
- If the input voltage line (B) on the TP sensor is opened. the ECM detects the output voltage is 0 V, then the OTC 8-1 ITP
sensor circuit low voltage) will be displayed.
MAP SENSOR
ECTSENSOA
- (lower than the specified value)
- (higher than the specified value).
SV
TPSENSOA
OUTPUT VOLTAGE
-
SV
OUTPUT VOLTAGE
-
FUEL SYSTEM (PGM-FI)
(B)
IAT SENSOR
5V
5V
OUTPUT VOLTAGE
5-11