Honda CB 600F Hornet 2007 Shop Manual page 449

HYDRAULIC BRAKE
Apply silicone grease to the piston contacting sur­
face of the push rod.
C8600F only:
Coat the master piston and piston cups with clean
brake fluid.
C8600F:
Install the spring onto the master piston.
Install the spring/master piston with the push rod
10 into the master cylinder.
Do not allow the
p1s1on cup lips
our
wrn insid9
Install the snap ring into the groove in the master
cylinder.
Make sure the snap
TOOL:
r,ng ,s firmly seated
tn the groove. Snap ring pliers
Apply silicone grease to the boot inside, and install
the boot into the master cylinder.
If the push rod joint is reinstalled, adjust the push
rod length so that the distance between the centers
of the master cylinder lower mounting bolt hole and
joint pin hole is 67.5 mm (2.66 in).
After adjustment, tighten the joint nut to the speci­
fied torque.
TORQUE: 17 N•m (1.7 kgf•m, 13 !bf.ft)
15-30
CB600F only:
MASTER PISTON
CB600F:
MASTER
CYLINDER
07914-SA50001
PUSH ROD ASSEMBLY
SPRING
I
.,..
a MASTER PISTON
JOINT NUT
67.5mm
(2.66 in)
PUSH ROD