Honda CB 600F Hornet 2007 Shop Manual page 415

Remove the right pivot radial ball bearings out
using the special tool.
TOOLS:
Bearing remover shaft. 20 mm 07936-3710600
Remover shaft handle
Remover weight
Press the left pivot needle bearing out using the
special tools and a hydraulic press.
TOOLS:
Needle bearing remover
attachment 07HMC-MR70100
07946-MJOOlOO
Driver shaft
Pack new ball bearings with grease.
Press the ball bearings into the swingarm right pivot
until they are fully seated, usinQ the special tools
and a hydraulic press.
TOOLS:
Driver
Outer driver attachment
Pilot, 20 mm
Pack a new needle bearing with grease.
Press the needle bearing into the swingarm left
pivot until the depth rrom the swingarm outer sur­
face is 5.0 - 6.0 mm (0.20 - 0.24 in) using the special
tools and a hydraulic press.
TOOLS:
Driver
Attachment, 37 X 40 mm
Pilot, 28 mm
07936-3710100
BEARING
07741-0010201
REMOVER
07749-0010000
07ZMD-MBW0200
07746-0040500
07749-0010000
07746-0010200
07JAD-PH80400
REAR WHEEUSUSPENSION
DRIVER SHAFT
TTACHMENT
�
l::!ALL 1::!1:AHINGS
5.0 - 6.0 mm
(0.20
$� -�
NEEDLE BEARING
\
\
\
\
\
\
BALL BEARINGS
-�
�
Fully seated
- 0.24 in)
14-21