Apply Honda Bond A, Honda hand grip cement or
equivalent to the inside surface of the right handle
bar grip and to the clean surfaces of the throttle
pipe.
Allow the adhesive
Wait 3-5 minutes and install the grip. Rotate the
dry tor 1 hour
ro
grip for even application of the adhesive.
before using.
Apply grease to the throttle pipe flange groove and
sliding areas.
Connect the throttle cables to the throttle pipe
flange.
Install the throttle pipe onto the handlebar.
Install the right handlebar switch/throttle housing
aligning its location pin with the hole in the handle
bar.
Tighten the forward screw first, then the rear screw.
FRONT WHEEL/SUSPENSION/STEERING
--� CABLE ENDS
HANDLEBAR
SWITCH/THROTTLE HOUSING
GRIP
�
GRIPfTHROTTLE PIPE
13-11