Honda CB 600F Hornet 2007 Shop Manual page 451

HYDRAULIC BRAKE
Secure the master cylinder with a new cotter pin.
Install the rear brake light switch into the stay on the
bracket.
Install the switch spring and brake pedal return
spring in the direction as shown.
Install the rear master cylinder mounting bolts.
Install the right footpeg bracket and mounting bolts,
then tighten the bolts to the specified torque.
TORQUE: 37 N·m (3.8 kgf•m, 27 lbf•ft)
Tighten the master cylinder mounting bolts to the
specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the muffler mounting bolt/nut, washer and
collar.
Tighten the muffler mounting nut to the specified
torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf•ft)
Connect the brake hose to the rear master cylinder
with the oil bolt and new sealing washers.
Tighten the oil bolt while holding the stopper of the
hose eyelet against the master cylinder.
TORQUE: 34 N•m (3.5 kgf·m, 25 lbf•ft)
15-32
RETURN SPRINGS
......
$�
COTTER PIN