Honda CB 600F Hornet 2007 Shop Manual page 334

Tighten the 10 mm bolt to the specified torque.
TORQUE: 39 N·m (4.0 kgf·m, 29 lbf·ft)
From the inside to outside, tighten the 6 mm bolts/
sealing washers to the specified torque.
TORQUE: 12 N•m (1.2 kgf•m, 9 lbf•ft)
Place the enqine with the lower side down.
The sealing washer
Install the 6 mm bolts with a new sealing washer.
loca11ons are ,ndi•
Tighten the 6 mm bolts to the specified torque.
cated on the upper
TORQUE: 12 N-m (1.2 kgf-m, 9 lbf-ft)
crankcase using the
•£).·mark.
Install the 8 mm bolt with a new sealing washer.
Tighten the 8 mm bolt to the specified torque.
TORQUE: 24 N-m (2.4 kgf-m, 18 lbf,ft)
CRANKCASE/TRANSMISSION
6 mm BOLTS/SEALING WASHERS �
6 mm BOLTS
6 mm BOLTS
6 mm BOLTS/ SEALING WASHER
8 mm BOLTS/ SEALING WASHER
�
s
�
11-17