Do not apply the
fronr or rear brake
during reroeval.
L
2.
Turn the ignition switch to "ON". The ABS indica
tor should come on 2 seconds (start signal) (then
goes off 3.6 seconds) and starts problem code
indication.
The problem code is indicated by the number of
the times of the indicator blinking.
If the problem code is not stored, the ABS indica
tor stays on.
3. Turn the ignition switch to "OFF" and remove the
jumper wire.
Connect the 3P (Natural) connector to the
dummy connector.
Install the seat (page 2-4).
CLEARING PROBLEM CODE
1. Short the wire terminals of the service check con
nector with a jumper wire with the ignition
switch turned to "OFF" in the same manner as
retrieval.
CONNECTION: Brown/white - Green
2. Turn the ignition switch to "ON" while squeezing
the brake lever. The ABS indicator should come
on 2 seconds and go off.
3. Release the brake lever immediately after the
ABS indicator is off. The ABS indicator should
come on.
4. Squeeze the brake lever immediately after the
ABS indicator is on. The ABS indicator should go
off.
5. Release the brake lever immediately after the
ABS indicator is off.
When code erasure is complete, the ABS indica
tor blinks 2 times and stays on.
6. Turn the ignition switch to "OFF".
ANTI-LOCK BRAKE SYSTEM (ABS; CB600FA)
JUMPER WIRE
3P (Natural)
ONNECTOR
\
�"'Lk
1
N
Green
ABS INDICATOR
16-9