Cooling System; Iat Sensor; Ect Sensor - Honda Transalp XL700V Manual

FUEL SYSTEM (PGM-FI)

IAT SENSOR

REMOVAL/INSTALLATION
Remove the air cleaner housing (page 5-62).
Remove the screws and IAT sensor from the air
cleaner housing.
Installation is in the reverse order of removal.
TORQUE:
IAT sensor mounting screw:
4.0 N·m (0.4 kgf·m, 3.0 lbf·ft)

ECT SENSOR

REMOVAL
Remove the thermostat (page 6-8).
Disconnect the ECT sensor 3P (Gray) connector.
Remove the ECT sensor and sealing washer.
INSTALLATION
Install a new sealing washer and ECT sensor.
Always replace a
Tighten the ECT sensor to the specified torque.
sealing washer with
a new one.
TORQUE: 24.5 N·m (2.5 kgf·m, 18 lbf·ft)
Connect the ECT sensor 3P (Gray) connector.
Install the thermostat (page 6-9).
Fill the cooling system with recommended coolant
(page 6-6).
5-72
IAT SENSOR SCREWS
3P (GRAY) CONNECTOR
SEALING WASHER
3P (GRAY) CONNECTOR
ECT SENSOR
ECT SENSOR
SEALING WASHER