Honda CB 600F Hornet 2007 Shop Manual page 246

Install the horn and tighten the bolt securely.
Route the horn wire through the stay clamp and
connect the horn wire connectors to the horn.
Connect the air bleed hose to the hose joint on the -�=:::11
cylinder head and tighten the hose band screw
securely.
Connect the water hose to the thermostat housing
cover and tighten the hose band screw securely.
&
Refer to 'CABLE Route the starter motor cable and ground cable.
HARNESS Tighten the starter motor mounting bolts with the
ROUTING" (page 1-
ground cable.
23)
Connect the starter motor cable, then tighten the
terminal nut to the specified torque.
TORQUE: 10 N·m (1.0 kgf•m, 7 lbf·ft)
Install the rubber cap securely.
ENGINE REMOVAL/INSTALLATION
HORN
CONNECTORS
7-13