Fuel Level Indicator - Honda CB 600F Hornet 2007 Shop Manual

Remove the rubber cap, and disconnect the EOP
switch wire by removing the terminal bolt.
Start the engine, check that the engine oil pressure
and warning indicators.
• If the indicators come on, check the following.
- Short circuit
- Faulty combination meter
• If the indicators do not come on, replace the EOP
switch.
If the engine oil pressure and warning indicators do
not function, check the following:
Remove the rubber cap, and disconnect the EOP
switch wire by removing the terminal bolt.
Ground the wire terminal to the engine using a
jumper wire.
Start the engine and check the engine oil pressure
and warning indicators.
• If the
switch.
• If the indicators still do not
following:
- open circuit in the EOP switch (Blue/red) wire
- faulty combination meter

FUEL LEVEL INDICATOR

SYSTEM INSPECTION
OPEN CIRCUIT IN THE FUEL LEVEL SYSTEM
If the fuel level indicator indicates as shown in the
right illustration, there are some open circuits in the
fuel level indicator system. Check the open circuit as
follows.
Litt and support the fuel tank (page 3-5).
Jump the Gray/black and Green wire terminals of
the fuel level sensor 2P (Natural) connector with
harness side using a jumper wire.
Turn the ignition switch to "ON" and check the fuel
level indicator.
• If the
circuit indication, check the following.
- Open circuit in the Gray/black and Green wires
between the combination meter and the fuel
level sensor
- Faulty combination meter circuit board (page
20-10)
• If the indicator indicates as "FULL", inspect the
fuel level sensor.
in the EOP switch (Blue/red) wire
indicators come on, replace the
function,
fuel level indicator still indicates as open
LIGHTS/METER/SWITCHES
EOP
check the
- - -
i)ft i)]-
--- --- --
El
l� ___J
�]=
- -
FUEL LEVEL INDICATOR
I
i) /
El
El-
20-17
El