Recall Commands - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:RECall Commands

Recall previously saved oscilloscope setups and traces. See
:RECall Commands"
Table 72 :RECall Commands Summary
Command
:RECall:FILename
<base_name> (see
page 398)
:RECall:IMAGe[:STARt]
[<file_spec>] (see
page 399)
:RECall:MASK[:STARt]
[<file_spec>] (see
page 400)
:RECall:PWD
<path_name> (see
page 401)
:RECall:SETup[:STARt]
[<file_spec>] (see
page 402)
Introduction to
The :RECall subsystem provides commands to recall previously saved
:RECall
oscilloscope setups and traces.
Commands
Reporting the Setup
Use :RECall? to query setup information for the RECall subsystem.
Return Format
The following is a sample response from the :RECall? query. In this case,
the query was issued following the *RST command.
:REC:FIL "scope_0"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 397.
Query
:RECall:FILename?
(see page 398)
n/a
n/a
:RECall:PWD? (see
page 401)
n/a
Commands by Subsystem
Options and Query Returns
<base_name> ::= quoted ASCII
string
<file_spec> ::= {<internal_loc>
| <file_name>}
<internal_loc> ::= 0-9; an
integer in NR1 format
<file_name> ::= quoted ASCII
string
<file_spec> ::= {<internal_loc>
| <file_name>}
<internal_loc> ::= 0-3; an
integer in NR1 format
<file_name> ::= quoted ASCII
string
<path_name> ::= quoted ASCII
string
<file_spec> ::= {<internal_loc>
| <file_name>}
<internal_loc> ::= 0-9; an
integer in NR1 format
<file_name> ::= quoted ASCII
string
5
"Introduction to
397