Trigger:i2S:source:data - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:I2S:SOURce:DATA

Command Syntax
:TRIGger:I2S:SOURce:DATA <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:I2S:SOURce:DATA command controls which signal is used as
the serial data (SDATA) source by the serial decoder and/or trigger when
in I2S mode.
Query Syntax
:TRIGger:I2S:SOURce:DATA?
The :TRIGger:I2S:SOURce:DATA? query returns the current source for the
I2S serial data (SDATA).
Return Format
<source><NL>
See Also
•
•
•
538
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:I2S:SOURce:CLOCk"
":TRIGger:I2S:SOURce:WSELect"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 467
on page 537
on page 539