Trigger:flexray:autosetup - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:FLEXray:AUTosetup

Command Syntax
:TRIGger:FLEXray:AUTosetup
The :TRIGger:FLEXray:AUTosetup command automatically configures
oscilloscope settings to facilitate FlexRay triggering and serial decode.
• Sets the selected source channel's impedance to 50 Ohms.
• Sets the selected source channel’s probe attenuation to 10:1.
• Sets the trigger level (on the selected source channel) to - 300 mV.
• Turns on trigger Noise Reject.
• Turns on Serial Decode.
• Sets the trigger type to FlexRay.
This command is only valid when the FLEXray triggering and serial decode option (Option
N O T E
FLX) has been licensed.
See Also
•
•
•
•
•
506
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:FLEXray:TRIGger"
":TRIGger:FLEXray:BAUDrate"
":TRIGger[:EDGE]:LEVel"
":TRIGger:FLEXray:SOURce"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 467
on page 516
on page 507
on page 501
on page 515