Trigger:sequence:timer - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:TRIGger:SEQuence:TIMer

Command Syntax
:TRIGger:SEQuence:TIMer <time_value>
<time_value> ::= time in seconds in NR1 format
The :TRIGger:SEQuence:TIMer command sets the sequencer timer resource
in seconds from 10 ns to 10 s. The timer is used in the reset stage to
determine how long to wait for the trigger to occur before restarting.
Query Syntax
:TRIGger:SEQuence:TIMer?
The :TRIGger:SEQuence:TIMer? query returns current sequencer timer
setting.
Return Format
<time value><NL>
<time_value> ::= time in seconds in NR1 format
See Also
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:SEQuence:RESet"
on page 467
on page 578
Commands by Subsystem
5
579