Agilent Technologies InfiniiVision 7000A Series Programmer's Manual page 282

5
Commands by Subsystem
Introduction to The HARDcopy subsystem provides commands to set and query the
:HARDcopy
selection of hardcopy device and formatting options such as inclusion of
Commands
instrument settings (FACTors) and generation of formfeed (FFEed).
:HARDC is an acceptable short form for :HARDcopy.
Reporting the Setup
Use :HARDcopy? to query setup information for the HARDcopy subsystem.
Return Format
The following is a sample response from the :HARDcopy? query. In this
case, the query was issued following the *RST command.
:HARD:APR "";AREA SCR;FACT 0;FFE 0;INKS 1;PAL NONE;LAY PORT
282 Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide