Autoscale:amode - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:AUToscale:AMODE

Command Syntax
:AUToscale:AMODE <value>
<value> ::= {NORMal | CURRent}
The :AUTOscale:AMODE command specifies the acquisition mode that is
set by subsequent :AUToscales.
• When NORMal is selected, an :AUToscale command sets the NORMal
• When CURRent is selected, the current acquisition type and mode are
Use the :ACQuire:TYPE and :ACQuire:MODE commands to set the
acquisition type and mode.
Query Syntax
:AUToscale:AMODE?
The :AUToscale:AMODE? query returns the autoscale acquire mode setting.
Return Format
<value><NL>
<value> ::= {NORM | CURR}
See Also
•
•
•
•
•
146
(see page 786)
acquisition type and the RTIMe (real- time) acquisition mode.
kept on subsequent :AUToscales.
"Introduction to Root (:) Commands"
":AUToscale" on page 144
":AUToscale:CHANnels"
":ACQuire:TYPE" on page 196
":ACQuire:MODE" on page 187
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 141
on page 147