5
Commands by Subsystem
:SAVE:WAVeform[:STARt]
Command Syntax
:SAVE:WAVeform[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WAVeform[:STARt] command saves oscilloscope waveform data
to a file.
If a file extension is provided as part of a specified <file_name>, and it does not match the
N O T E
extension expected by the format specified in :SAVE:WAVeform:FORMat, the format will be
changed if the extension is a valid waveform file extension.
See Also
•
•
•
•
•
416
(see
page
786)
"Introduction to :SAVE Commands"
":SAVE:WAVeform:FORMat"
":SAVE:WAVeform:LENGth"
":SAVE:FILename"
on page 405
":RECall:SETup[:STARt]"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 404
on page 417
on page 418
on page 402