5
Commands by Subsystem
:WAVeform:SOURce:SUBSource
Command Syntax
:WAVeform:SOURce:SUBSource <subsource>
<subsource> ::= {{NONE | RX} | TX}
If the :WAVeform:SOURce is SBUS (serial decode), more than one data set
may be available, and this command lets you choose from the available
data sets.
Currently, only UART serial decode lets you get "TX" data. The default,
NONE, specifies "RX" data. (RX is an alias for NONE.)
If the :WAVeform:SOURce is not SBUS, or the :SBUS:MODE is not UART,
the only valid subsource is NONE.
Query Syntax
:WAVeform:SOURce:SUBSource?
The :WAVeform:SOURce:SUBSource? query returns the current waveform
subsource setting.
Return Format
<subsource><NL>
<subsource> ::= {NONE | TX}
See Also
•
•
642
(see
page
786)
"Introduction to :WAVeform Commands"
":WAVeform:SOURce"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 618
on page 638