Waveform:type - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:WAVeform:TYPE

Query Syntax
:WAVeform:TYPE?
The :WAVeform:TYPE? query returns the acquisition mode associated with
the currently selected waveform. The acquisition mode is set by the
:ACQuire:TYPE command.
Return Format
<mode><NL>
<mode> ::= {NORM | PEAK | AVER | HRES}
If the :WAVeform:SOURce is POD1, POD2, or SBUS, the type is always NORM.
N O T E
See Also
•
•
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :WAVeform Commands"
":ACQuire:TYPE" on page 196
":WAVeform:DATA" on page 626
":WAVeform:PREamble"
":WAVeform:SOURce"
on page 618
on page 633
on page 638
Commands by Subsystem
5
643