Agilent Technologies InfiniiVision 7000A Series Programmer's Manual page 752

9
Status Reporting
Error
Queue
RUN
Bit
Arm Event
Register
Overload Overload
Event Event
Register Enable
Register
Hardware Hardware
Event Event
Condition/ Enable
Event Register
Registers
Mask Test
Mask Test
Event
Event
Register
Enable
Register
• To monitor an event, first clear the event; then, enable the event. All of
• To allow a service request (SRQ) interrupt to an external controller,
The Status Byte Register, the Standard Event Status Register group, and
the Output Queue are defined as the Standard Status Data Structure
Model in IEEE 488.2- 1987.
752
Standard
Event
Status
Register
Operation
Status
Condition/
Event
Registers
the events are cleared when you initialize the instrument.
enable at least one bit in the Status Byte Register (by setting, or
unmasking, the bit in the Service Request Enable register).
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
Trigger Event
Register
Message
Queue
Output
Queue
Status
(Mask)
Byte
Register
Standard
Event
Status
Enable
Register
(Mask)
Operation
Status
Enable
Register
(Mask)
Service
Request
Enable
Register
Service
Request
Generation
Service
Request (SRQ)
Interrupt
to Computer