Function:source - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

7
Obsolete and Discontinued Commands

:FUNCtion:SOURce

Command Syntax
:FUNCtion:SOURce <value>
<value> ::= {CHANnel<n> | ADD | SUBTract | MULTiply}
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :FUNCtion:SOURce command is only used when an FFT (Fast Fourier
Transform), DIFF, or INT operation is selected (see
the:FUNCtion:OPERation command for more information about selecting an
operation). The :FUNCtion:SOURce command selects the source for
function operations. Choose CHANnel<n>, or ADD, SUBT, or MULT to
specify the desired source for function DIFFerentiate, INTegrate, and FFT
operations specified by the :FUNCtion:OPERation command.
The :FUNCtion:SOURce command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. Use the :FUNCtion:SOURce1 command (see
Query Syntax
:FUNCtion:SOURce?
The :FUNCtion:SOURce? query returns the current source for function
operations.
Return Format
<value><NL>
<value> ::= {CHAN<n> | ADD | SUBT | MULT}
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
See Also •
•
704
(see page 786)
"Introduction to :FUNCtion Commands"
":FUNCtion:OPERation"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 266
on page 273
page 277) instead.