Trigger:flexray:channel - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:FLEXray:CHANnel

Command Syntax
:TRIGger:FLEXray:CHANnel <channel>
<channel> ::= {A | B}
The :TRIGger:FLEXray:CHANnel command specifies the bus channel, A or
B, of the FlexRay signal.
This command is only valid on 4 (analog) channel oscilloscope models when the FlexRay
N O T E
triggering and serial decode option (Option FLX) has been licensed.
Query Syntax
:TRIGger:FLEXray:CHANnel?
The :TRIGger:FLEXray:CHANnel? query returns the current bus channel
setting.
Return Format
<channel><NL>
<channel> ::= {A | B}
See Also
•
•
508
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:FLEXray Commands"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 467
on page 505