Blank - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:BLANk

Command Syntax
:BLANk [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH | SBUS} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15 | POD{1 | 2}
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :BLANk command turns off (stops displaying) the specified channel,
digital pod, math function, or serial decode bus. The :BLANk command
with no parameter turns off all sources.
To turn on (start displaying) a channel, etc., use the :VIEW command. The DISPlay
N O T E
commands, :CHANnel<n>:DISPlay, :FUNCtion:DISPlay, :POD<n>:DISPlay, or
:DIGital<n>:DISPlay, are the preferred method to turn on/off a channel, etc.
MATH is an alias for FUNCtion.
N O T E
See Also
•
•
•
•
•
•
•
•
Example Code •
148
(see page 786)
| BUS{1 | 2} | FUNCtion | MATH | SBUS} for the MSO models
"Introduction to Root (:) Commands"
":CDISplay" on page 149
":CHANnel<n>:DISPlay"
":DIGital<n>:DISPlay"
":FUNCtion:DISPlay"
":POD<n>:DISPlay" on page 393
":STATus" on page 177
":VIEW" on page 180
"Example Code" on page 180
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 141
on page 222
on page 239
on page 268