Trigger:spi:clock:slope - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:SPI:CLOCk:SLOPe

Command Syntax
:TRIGger:SPI:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:SPI:CLOCk:SLOPe command specifies the rising edge
(POSitive) or falling edge (NEGative) of the SPI clock source that will
clock in the data.
Query Syntax
:TRIGger:SPI:CLOCk:SLOPe?
The :TRIGger:SPI:CLOCk:SLOPe? query returns the current SPI clock
source slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
582
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:SPI:CLOCk:TIMeout"
":TRIGger:SPI:SOURce:CLOCk"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 467
on page 583
on page 587