Trigger:uart:source:rx - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:TRIGger:UART:SOURce:RX

Command Syntax
:TRIGger:UART:SOURce:RX <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:UART:SOURce:RX command controls which signal is used as
the Rx source by the serial decoder and/or trigger when in UART mode.
Query Syntax
:TRIGger:UART:SOURce:RX?
The :TRIGger:UART:SOURce:RX? query returns the current source for the
UART Rx signal.
Return Format
<source><NL>
See Also •
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 473
":TRIGger:UART:TYPE"
":TRIGger:UART:BITorder"
on page 467
on page 609
on page 600
Commands by Subsystem
5
607