Mtest:rumode - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:MTESt:RUMode

Command Syntax
:MTESt:RUMode {FORever | TIME,<seconds> | {WAVeforms,<wfm_count>}}
<seconds> ::= from 1 to 86400 in NR3 format
<wfm_count> ::= number of waveforms in NR1 format
The :MTESt:RUMode command determines the termination conditions for
the mask test. The choices are FORever, TIME, or WAVeforms.
• FORever — runs the Mask Test until the test is turned off.
• TIME — sets the amount of time in seconds that a mask test will run
• WAVeforms — sets the maximum number of waveforms that are required
The :MTESt:RUMode command is obsolete and is provided for backward compatibility to
N O T E
previous oscilloscopes. Use the :MTESt:RMODe command (see
Query Syntax
:MTESt:RUMode?
The :MTESt:RUMode? query returns the currently selected termination
condition and value.
Return Format
{FOR | TIME,<seconds> | {WAV,<wfm_count>}}<NL>
<seconds> ::= from 1 to 86400 in NR3 format
<wfm_count> ::= number of waveforms in NR1 format
See Also
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
from 1 to 1,000,000,000
before it terminates. The <seconds> parameter is a real number from 1
to 86400 seconds.
before the mask test terminates. The <wfm_count> parameter indicates
the number of waveforms that are to be acquired; it is an integer from
1 to 1,000,000,000.
from 1 to 1,000,000,000
"Introduction to :MTESt Commands"
":MTESt:RUMode:SOFailure"
Obsolete and Discontinued Commands
on page 360
on page 732
page 377) instead.
731
7