Agilent Technologies InfiniiVision 7000A Series Programmer's Manual page 130

5
Commands by Subsystem
Trigger Menu
Slope
HF Reject and noise reject
Holdoff
External probe attenuation
External Units
External Impedance
See Also
•
Example Code
Example program from the start:
page 812
130
"Introduction to Common (*) Commands"
' RESET - This command puts the oscilloscope into a known state.
' This statement is very important for programs to work as expected.
' Most of the following initialization commands are initialized by
' *RST. It is not necessary to reinitialize them unless the default
' setting is not suitable for your application.
myScope.WriteString "*RST"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
Positive
Off
60 ns
AutoProbe (if AutoProbe is connected),
otherwise 1.0:1
Volts
1 M Ohm
on page 116
' Reset the oscilloscope to the defaults.
"VISA COM Example in Visual Basic" on