Trigger:flexray:source - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:TRIGger:FLEXray:SOURce

Command Syntax
:TRIGger:FLEXray:SOURce <source>
<source> ::= {CHANnel<n>}
<n> ::= {1 | 2 | 3 | 4}
The :TRIGger:FLEXray:SOURce command specifies the input source for the
FlexRay signal.
This command is only valid when the FLEXray triggering and serial decode option (Option
N O T E
FLX) has been licensed.
Query Syntax
:TRIGger:FLEXray:SOURce?
The :TRIGger:FLEXray:SOURce? query returns the current source for the
FlexRay signal.
Return Format
<source><NL>
See Also •
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:FLEXray:TRIGger"
":TRIGger:FLEXray:EVENt:TYPE"
":TRIGger:FLEXray:AUTosetup"
Commands by Subsystem
on page 467
on page 516
on page 510
on page 506
5
515