Trigger:mode - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:TRIGger:MODE

Command Syntax
:TRIGger:MODE <mode>
<mode> ::= {EDGE | GLITch | PATTern | CAN | DURation | I2S |IIC
The :TRIGger:MODE command selects the trigger mode (trigger type).
Query Syntax
:TRIGger:MODE?
The :TRIGger:MODE? query returns the current trigger mode. If the
:TIMebase:MODE is ROLL or XY, the query returns "NONE".
Return Format
<mode><NL>
<mode> ::= {NONE | EDGE | GLIT | PATT | CAN | DUR | I2S
See Also •
•
•
Example Code
Example program from the start:
page 812
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
| EBURst | LIN | M1553| SEQuence | SPI | TV | UART
| USB | FLEXray}
| IIC | EBUR | LIN | M1553| SEQ | SPI | TV | UART
| USB | FLEX}
"Introduction to :TRIGger Commands"
":TRIGger:SWEep" on page 477
":TIMebase:MODE" on page 457
' TRIGGER_MODE - Set the trigger mode to EDGE.
myScope.WriteString ":TRIGGER:MODE EDGE"
Commands by Subsystem
on page 467
"VISA COM Example in Visual Basic"
5
on
473