5
Commands by Subsystem
:DISPlay:CLEar
Command Syntax
:DISPlay:CLEar
The :DISPlay:CLEar command clears the display and resets all associated
measurements. If the oscilloscope is stopped, all currently displayed data
is erased. If the oscilloscope is running, all of the data for active channels
and functions is erased; however, new data is displayed on the next
acquisition.
See Also
•
•
246
(see
page
786)
"Introduction to :DISPlay Commands"
":CDISplay"
on page 149
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 244