Trigger:usb:source:dminus - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:USB:SOURce:DMINus

Command Syntax
:TRIGger:USB:SOURce:DMINus <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:USB:SOURce:DMINus command sets the source for the USB
D- signal.
Query Syntax
:TRIGger:USB:SOURce:DMINus?
The :TRIGger:USB:SOURce:DMINus? query returns the current source for
the USB D- signal.
Return Format
<source><NL>
See Also •
•
•
•
612
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 473
":TRIGger:USB:SOURce:DPLus"
":TRIGger:USB:TRIGger"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 467
on page 613
on page 615