Run - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:RUN

Command Syntax
:RUN
The :RUN command starts repetitive acquisitions. This is the same as
pressing the Run key on the front panel.
See Also •
•
•
Example Code
Example program from the start:
page 812
174
(see page 786)
"Introduction to Root (:) Commands"
":SINGle" on page 176
":STOP" on page 178
' RUN_STOP - (not executed in this example)
' - RUN starts the data acquisition for the active waveform display.
' - STOP stops the data acquisition and turns off AUTOSTORE.
' myScope.WriteString ":RUN"
' myScope.WriteString ":STOP"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 141
' Start data acquisition.
' Stop the data acquisition.
"VISA COM Example in Visual Basic" on