Function Commands - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:FUNCtion Commands

Control functions in the measurement/storage module. See
:FUNCtion Commands"
Table 65 :FUNCtion Commands Summary
Command
:FUNCtion:CENTer
<frequency> (see
page 267)
:FUNCtion:DISPlay {{0
| OFF} | {1 | ON}}
(see page 268)
:FUNCtion:GOFT:OPERat
ion <operation> (see
page 269)
:FUNCtion:GOFT:SOURce
1 <source> (see
page 270)
:FUNCtion:GOFT:SOURce
2 <source> (see
page 271)
:FUNCtion:OFFSet
<offset> (see
page 272)
:FUNCtion:OPERation
<operation> (see
page 273)
264
on page 266.
Query
:FUNCtion:CENTer?
(see page 267)
:FUNCtion:DISPlay?
(see page 268)
:FUNCtion:GOFT:OPERat
ion? (see page 269)
:FUNCtion:GOFT:SOURce
1? (see page 270)
:FUNCtion:GOFT:SOURce
2? (see page 271)
:FUNCtion:OFFSet?
(see page 272)
:FUNCtion:OPERation?
(see page 273)
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
Options and Query Returns
<frequency> ::= the current
center frequency in NR3 format.
The range of legal values is from
0 Hz to 25 GHz.
{0 | 1}
<operation> ::= {ADD | SUBTract |
MULTiply}
<source> ::= CHANnel<n>
<n> ::= {1 | 2 | 3 | 4} for 4ch
models
<n> ::= {1 | 2} for 2ch models
<source> ::= CHANnel<n>
<n> ::= {{1 | 2} | {3 | 4}} for
4ch models, depending on SOURce1
selection
<n> ::= {1 | 2} for 2ch models
<offset> ::= the value at center
screen in NR3 format.
The range of legal values is
+/-10 times the current
sensitivity of the selected
function.
<operation> ::= {ADD | SUBTract |
MULTiply | INTegrate |
DIFFerentiate | FFT | SQRT}
"Introduction to