Agilent Technologies InfiniiVision 7000A Series Programmer's Manual page 112

5
Commands by Subsystem
Subsystem
":MEASure Commands"
":MTESt Commands"
":POD Commands"
":RECall Commands"
":SAVE Commands"
":SBUS Commands"
":SYSTem Commands"
":TIMebase Commands"
":TRIGger Commands"
":WAVeform Commands"
Command Types
Three types of commands are used:
• Common (*) Commands — See
• Root Level (:) Commands — See
• Subsystem Commands — Subsystem commands are grouped together
112
on page 306
on page 358
on page 392
on page 397
on page 403
on page 420
on page 445
on page 455
on page 467
on page 616
Commands" on page 116 for more information.
on page 141 for more information.
under a common node of the
:TIMebase commands. Only one subsystem may be selected at any given
time. When the instrument is initially turned on, the command parser is
set to the root of the command tree; therefore, no subsystem is
selected.
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
Description
Select automatic measurements to be made
and control time markers.
Control the mask test features provided with
Option LMT.
Control all oscilloscope functions associated
with groups of digital channels.
Recall previously saved oscilloscope setups
and traces.
Save oscilloscope setups and traces, screen
images, and data.
Control oscilloscope functions associated with
the serial decode bus.
Control basic system functions of the
oscilloscope.
Control all horizontal sweep functions.
Control the trigger modes and parameters for
each trigger type.
Provide access to waveform data.
"Introduction to Common (*)
"Introduction to Root (:) Commands"
"Command Tree" on page 791, such as the