Agilent Technologies InfiniiVision 7000A Series Programmer's Manual page 632

5
Commands by Subsystem
• :TIMebase:MODE must be set to MAIN.
• :ACQuire:TYPE must be set to NORMal, AVERage, or HRESolution. If
• MAXimum or RAW will allow up to 8,000,000 points to be returned. The
Query Syntax
:WAVeform:POINts:MODE?
The :WAVeform:POINts:MODE? query returns the current points mode.
Setting the points mode will affect what data is transferred. See the
discussion above.
Return Format
<points_mode><NL>
<points_mode> ::= {NORMal | MAXimum | RAW}
See Also
•
•
•
•
•
•
•
•
•
•
632
AVERage, :ACQuire:COUNt must be set to 1 in order to return more
than the measurement record or precision analysis record.
number of points returned will vary as the instrument's configuration is
changed. Use the :WAVeform:POINts? MAXimum query to determine the
maximum number of points that can be retrieved at the current
settings.
"Introduction to :WAVeform Commands"
":WAVeform:DATA" on page 626
":ACQuire:POINts" on page 188
":SYSTem:PRECision"
":WAVeform:VIEW" on page 645
":WAVeform:PREamble"
":WAVeform:POINts" on page 629
":TIMebase:MODE" on page 457
":ACQuire:TYPE" on page 196
":ACQuire:COUNt" on page 185
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 618
on page 450
on page 633