:TRIGger:UART:POLarity
Command Syntax
:TRIGger:UART:POLarity <polarity>
<polarity> ::= {HIGH | LOW}
The :TRIGger:UART:POLarity command selects the polarity as idle low or
idle high for the serial decoder and/or trigger when in UART mode.
Query Syntax
:TRIGger:UART:POLarity?
The :TRIGger:UART:POLarity? query returns the current UART polarity
setting.
Return Format
<polarity><NL>
<polarity> ::= {HIGH | LOW}
See Also
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see
page
786)
"Introduction to :TRIGger Commands"
":TRIGger:MODE"
on page 473
":TRIGger:UART:TYPE"
on page 467
on page 609
Commands by Subsystem
5
605