Mtest:output - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

5
Commands by Subsystem

:MTESt:OUTPut

Command Syntax
:MTESt:OUTPut <signal>
<signal> ::= {FAIL | PASS}
The :MTESt:OUTPut command selects the mask test output condition:
• FAIL — the output occurs when there are mask test failures.
• PASS — the output occurs when the mask test passes.
You can place the mask test signal on the rear panel TRIG OUT BNC using
the
Query Syntax
:MTESt:OUTPut?
The :MTESt:OUTPut? query returns the currently set output signal.
Return Format
<signal><NL>
<signal> ::= {FAIL | PASS}
See Also
•
•
376
(see page 786)
":CALibrate:OUTPut"
"Introduction to :MTESt Commands"
":CALibrate:OUTPut"
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
on page 211 command.
on page 360
on page 211