Trigger:glitch:qualifier - Agilent Technologies InfiniiVision 7000A Series Programmer's Manual

:TRIGger:GLITch:QUALifier

Command Syntax
:TRIGger:GLITch:QUALifier <operator>
<operator> ::= {GREaterthan | LESSthan | RANGe}
This command sets the mode of operation of the glitch pulse width trigger.
The oscilloscope can trigger on a pulse width that is greater than a time
value, less than a time value, or within a range of time values.
Query Syntax
:TRIGger:GLITch:QUALifier?
The :TRIGger:GLITch:QUALifier? query returns the glitch pulse width
qualifier.
Return Format
<operator><NL>
<operator> ::= {GRE | LESS | RANG}
See Also
•
•
•
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
(see page 786)
"Introduction to :TRIGger Commands"
":TRIGger:GLITch:SOURce"
":TRIGger:MODE" on page 473
on page 467
on page 525
Commands by Subsystem
5
523